Supercourse 500

SUPERCOURSE 500

Synthetic Damp Proof Course (DPC)



Supercourse 500 is a general damp-proof course (DPC) used to prevent moisture transfer between building materials.  It is also used as a concealed flashing for masonry veneer cladding. 


Manufactured using a single layer of black polyethylene, Supercourse 500 is tough, high-impact and tear resistant.  It is a suitable moisture impermeable alternative to bituminous DPC. 

Product Specifications

Supercourse 500 comes in nine roll sizes:

Product Code Roll Size Rolls per Carton
SPC05030 50mm x 30m 42
SPC07530 75mm x 30m 24
SPC09030 90mm x 30m 24
SPC10030 100mm x 30m 18
SPC15030 150mm x 30m 12
SPC20030 200mm x 30m 6
SPC25030 250mm x 30m 6
SPC30030 300mm x 30m 6
SPC50030 500mm x 30m

Scope of use

  • Supercourse 500 is intended for use as a damp-proof course separating timber and wood based products and metal from concrete, masonry elements or clay bricks. 
  • Can also be used to separate timber jack studs or bearers from concrete or timber piles.
  • Supercourse 500 can be used as a concealed flashing in masonry veneer walls.   

General

  • Unaffected by LOSP or other solvent based treated timber.  However, LOSP or other solvent based treated timber must have sufficient time for solvent chemical to flash off in well ventilated area.  Recommended minimum 7 days. 
  • Available in nine product width sizes. 

Limitations

  • Maximum weather or UV exposure in 30 days.
  • Supercourse 500 is NOT a window flashing tape and NOT a thermal break product. 

Compliance

When Supercourse 500 is used and installed as a damp-proof course and/or concealed flashing behind masonry veneer walls, the product will meet or contribute to meeting the following provisions of the NZBC:

  • Clause B2 Durability: Performance B2.3.1 (a), 50 years and B.2.3.2.
  • Clause E2 External Moisture: Performance E2.3.2 and E2.3.3.  When used as flashing as part of a masonry veneer cladding system, Supercourse 500 will contribute to meeting the requirement of E2.3.2.  When used as a damp-proof course, Supercourse 500 will meet the requirements of E2.3.3.
  • Clause F2 Hazardous Building Materials: Performancee F2.3.1.  Supercourse 500 meets this requirement and will not present a health hazard to people. 

More details can be found in Supercourse 500 BRANZ Appraisal 329 (2022). 


Durability

Supercourse 500 is expected to have a serviceable life in excess of 50 years when it is:

  • Installed in accordance with Thermakraft's literature and BRANZ Appraisal. 
  • Not over exposed to the weather or UV (not more than 30 days).
  • Never exposed to chemicals or solvents that will degrade or affect polyethylene material. 

Product Warranty

Standard Thermakraft warranty applies. Refer to Thermakraft Warranty Statement for further details. This item is available online here or call 0800 806 595.

Related products

watergate

Watergate Plus

New Zealand’s premium all-purpose, fire retardant wall wrap. Watergate offers high water resistance and water vapour permeability. It is tried, tested and trusted by most New Zealand builders.

Read full specifications.


roof

Thermakraft 220

Lightweight synthetic, fire retardant underlay for use on timber and steel framing behind exterior wall cladding.

Read full specifications.


Thermakraft+213

Thermakraft 213

Non self-supporting bituminous wall and roof underlay for timber and steel framed buildings. Match with Ausnet hexagonal wire mesh.

Read full specifications.


Thermathene+Orange

Perimeter Damp Proof Course (DPC)

Bitumin-based Damp Proof Course used as a moisture barrier between framing and concrete, masonry or brick.

Read full specifications.

Share by: